Build log date: Sunday, February 15, 2004

• My neighbor Joe helped me use a hammer (yuck!) to dimple the rudder cable hold downs.

  

• Fitting the ground terminal plate in position.

  

• Post riveting on the firewall side.

  

• I fabricated aluminum spacers for the elevator horn/pushrod bolt. The washers would have been a nightmare to deal with. (Done per plans)

  

• Adjusted the length on the pitch servo pushrod - I think this is good for flight, except for torquing jam nuts.

  

• Drill holes for the brake lines between the passenger and pilot peddals.

  

• Installed the bulkhead fittings where the brake lines go to the wheels.