Build log date: Wednesday, September 01, 2004

• Rough cut the cowl oil door.

  

• Marking the initial cut lines on the oil door.

  

• Fabbed the oil door hinge - test fitting for the cut.

  

• The oil door is now sanded to size.

  

• Test fit of the oil door hinge - spacers will be needed.

  

• The hinge is drilled to the cowl, about to drill to the door.

  

• A scary picture of me to keep the FAA happy. Notice the spacers on the oil door.

  

• Begin cutting the hartwell latches in the oil door.

  

• The latches are mostly done - a little bit more trimming.

  

• Making the initial cut in the cowl for the nose gear leg.

  

• The bottom cowl can now slide on far enough to mark trim lines