Build log date: Thursday, November 20, 2003

• The left gear hole is part way drilled - lots of grinding, fitting, grinding, fitting...

  

• While these EF-661 bearings were in the plane I drilled a small amount of the second hole. I removed the bearings and moved to the drill press to finish the hole cause I wanted to make sure the hole was square to the surface.

  

• Bent the seat back channels so that the support can easily slide in.

  

• The seats are finally done. I dinged one of the upper hinge rivets pretty good, but a repair turned out to be reasonably effective.

  

• This fuzzy picture shows me drilling a hole for safety wire at the end of the electric flap mechanism. The safety wire ensures that the assembly can not unscrew itself if the jam nut gets loose.